The ESWGP510-2SFP-T is a fully managed, full Gigabit PoE+ industrial switch, with eight (8) 802.3 af/at compliant Ethernet ports. The switch provides up to 30 Watts of power per port and offers two (2) SFP slots for Gigabit fiber or copper SFPs.
The ESWGP510-2SFP-T is perfect for high bandwidth applications such as CCTV and IEEE 802.11ac Wi-Fi, and where reliability and managability are required in industrial or hard to reach places. With two (2) gigabit SFP slots this switch provides the flexibility and capability of redundancy and daisy chain networks. The SFP ports support both copper and fiber SFPS. 100Mbps SFPs are not supported.
Power over Ethernet PoE+ 802.3at provides 30W of power per port and is backwards compatible with 802.3.af devices. The switch detects and classifies a PD device before providing the required power to the PD device. PoE power simplifies the installation of PD devices by eliminating the need for additional cable and power supplies.
VLAN Configuration: A Virtual LAN (VLAN) is a logical network grouping that limits the broadcast domain. This allows you to isolate network traffic so that members of a VLAN will only receive traffic from other members of the same VLAN. Creating a VLAN from a switch is the logical equivalent of reconnecting a group of network devices to another Layer 2 switch. However, since it is a virtual network, the network devices remain physically connected to the same switch. Both port-based and 802.1Q (tagged-based) VLAN are supported.
RingOn Technology: Two ports can be used for network redundancy by implementing RingOn technology. This provides a rapid recovery system for industrial networks. If any part of the ring disconnects, the network communications will automatically be restored.
Wide Operating Temperature: With an operating temperature of -40 to 85°C (-40 to 185°F), this switch is suitable for use in some of the harshest industrial environments.
Remote PoE+ Reset: Dip switch selectable, the PoE+ reset works on fiber loss off signal on both slots. PoE+ reset is an advanced function that, when enabled, will force the PSE output power to reset when LINK state is lost on the SFP ports
Easy Troubleshooting: LED indicators allow you to quickly diagnose and correct problems and ensure that your network remains reliable.
