|
|
ACL-7125 - 8CH Relay Actuator & Isolated D/I Card by ADLINK
|
|
|
** ACL-7125 will be discontinued on June 15, 2018.**
**Last time buy date: June 15, 2018.**
**Last time ship date: December 31, 2018**
** Replacement Models:LPCI-7250 or PCI-7250 **
- PC AT bus
- 4-CH SPDT (Form C) and 4-CH SPST (Form A) relays
- Nonlatching relays
- On-board LED indicators for relay status
- On-board relay driving circuits
- Relay output status read back
- 8-CH isolated digital inputs
- On-board low-pass filtering for digital inputs
|
|
|
ADLINK ACL-7125 provides 8-CH relay outputs and 8-CH isolated digital inputs.
Four of the relays are SPDT (Form C) and four are SPST (Form A), which are
suitable for device connection with ON/OFF control. The status of each relay
output is represented by an on-board LED. When the relay is energized, its
corresponding LED will turn ON, otherwise it is OFF. All of the digital input
channels are non-polarity and optically isolated. Users can set for each digital
input by using RC filter or not. The device is suitable for collecting digital
inputs in noisy environments.
Relay Outputs
- Relay Type: Double-Pole-Double-Throw (DPDT)
- Number of Relays: 8 (R0~R4 are in Form C; R5~R7 are in Form A).
- Contact Rating: 0.5A @ 120VAC; 1A @ 24VDC
- Breakdown Voltage: 1000 V AC or DC (minimum)
- Contact Type: Bifurcated
- Insulation Resistance: 100MΩ Max.
- Relay ON/OFF Time: 5 m sec. (typical); 10 m sec (maximum)
- Life Expectancy: > 10 million operations at full load
- Coil Voltage: +12V @33mA for each relay; total 0.264 A if all relay
Are energized.
Isolated Inputs
- Number of channels: 8
- Opto-Isolator: PC-814 or compatible
- Input Signal Type: AC (don't care polarity) or DC
- Input Voltage: up to 24VDC or 24VAC 50 ~1,000 Hz
- Threshold Voltage: 2.4VDC
- Input Current: 20 mA (maximum)
- Input Resistor: 1.2 KΩ
- Isolation Voltage: 2500Vrms channel-to-ground
- Response Time: 20 µsec without AC Filter, 2.2 ms with AC Filter
General Specifications
- I/O Connectors: One 37-pin Female D-type connector,
- Bus Interface: 16-bit ISA Bus
- Operating Temperature: 0° C ~ 55° C
- Storage Temperature: -20° C ~ 80° C
- Humidity: 5 ~ 90%, non-condensing
- Dimension: 148mm(L) X 107mm(W)
Power Consumption
- +5VDC: 130 mA typical
- +12VDC: 180 mA maximum, all relays are energized
|
|