|
|
|
- Redundant power inputs
- Wide operating temperature
- Extend Ethernet up to 6232 ft. (1.9 km) over standard copper wires
- Ethernet port: RJ-45 10/100Mbps
- Full/Half-duplex, Auto-negotiation / Auto-MDI/MDX
- Ethernet extend port: RJ-11 50Mbps full duplex VDSL
- UL/CUL Class 1/Division 2 Groups A, B, C, D • NEMA TS2
|
|
|
The EIR-EXTEND is a point-to-point Ethernet Extender designed to operate in harsh environments. Functioning at temperatures from -40 to 75º C, it has been tested for functional operation up to 85º C. Using existing copper wire runs, it allows the extension of Ethernet signals. The EIR-EXTEND is the perfect solution for installing Ethernet connectivity on the factory floor. Used in pairs, configuration is easy. Configure one unit as the local device, and the other one as the remote device. External power supplies are required (not included).
| EIR-EXTEND |
| Speed |
Distance Up To |
| 1 Mbps |
6200 ft. (1900 m) |
| 10 Mbps |
4500 ft. (1400 m) |
| 20 Mbps |
3200 ft. (1000 m) |
| 30 Mbps |
2550 ft. (700 m) |
| 50 Mbps |
980 ft. (300 m) |
EIR-EXTEND
- Extender Interface: RJ-11 or Terminal Block
- Ethernet Interface: one 10/100BaseTX port with RJ-45 connector
- Power: Redundant 12 – 30 VDC Terminal Block, 12 VDC – Power Jack (Power Supply Optional)
- Operating Temp: -40º to 75º C (Tested to 85º C)
- Enclosure: DIN Mount IP30 Aluminum
EIR-EXTEND-4
- UL508 and NEMA TS1 & TS2 Environmental requirements for Traffic control equipment
- IEC61000-6-2 EMC for Heavy Industrial environment
- Extender Interface: RJ-11 or Terminal Block
- Ethernet Interface: four 10/100BaseTX port with RJ-45 connector
- Power: Redundant 24 – 48 VDC Terminal Block, 48 VDC – Power Jack (Power Supply Optional)
- Operating Temp: -40º to 75º C (Tested to 85º C)
- Enclosure: DIN Mount IP30 Aluminum
| Distances Up To |
| Speed |
EIR-EXTEND |
| 1 Mbps |
6200 ft. (1900 m) |
| 10 Mbps |
4500 ft. (1400 m) |
| 20 Mbps |
3200 ft. (1000 m) |
| 30 Mbps |
2550 ft. (700 m) |
| 50 Mbps |
980 ft. (300 m) |
|
|
