|
|
|
CL1212E/EUI-2PK - Extended Temperature CopperLink High Speed Auto Rate Extender Kit (Local and Remote); 2 x 10/100BaseTX; RJ45 L
by PATTON
|
|
|
|
- Ethernet Extension—Extend 10/100Base-TX Ethernet well beyond its 328-foot (100-meter) limitation over a single unshielded twisted pair (UTP), Cat 5e/6/7 cable.
- Operates Over Twisted Pair—Realize fiber-optic speeds without the expense—and hassle—of installing new cables or line-of-sight wireless circuits.
- Plug and Play—Set these units up straight out of the box. No configuration is required. Auto-sensing 10/100 Ethernet ports support full or half duplex operation.
- Multiple Line Rates Supported—Switch-selectable rate mode options optimize rate and reach for the noise environment, wire gauge/type and length.
- Transparent LAN Bridging—Bypass network configuration requirements by transparently passing all higher layer protocols—including 802.1Q VLAN frames (tagged and untagged).
- Made in the USA — This Patton equipment is designed by Patton engineers and built in our Gaithersburg, Maryland facility. Patton's American-made manufacturing process delivers high-quality networking solutions with reliability you can trust.
|
|
|
The Patton Model CL1212E-EUI-2PK eliminates the bandwidth constraints commonly experienced with other copper-based transmission technologies. The Model 1212E is engineered to re-use existing infrastructure previously employed in legacy applications including alarm circuits, E1/T1 circuits, RS-232, RS-422, RS-485, CCTV and CATV. Many newer cabling standards are also supported, including Cat 5e, Cat 6 and Cat 7.
A built-in 2-port Ethernet switch makes the CopperLink Model 1212E ideal for delivering simultaneous connectivity to more than one IP enabled device such as a laptop, a motion sensor, or even a few high resolution IP video cameras—all over a single twisted-pair!
A single-port version, the CopperLink Model CL1211E (available by special order) is ideal for applications requiring the enhanced security of a single Ethernet port.
| CopperLink Line Interface |
- RJ-45 (pin 4 = ring; pin 5 = tip)
- BNC 75-ohm coax
- Terminal block, 2 position
|
| CopperLink Line Modulation |
DMT (Discrete Multi-Tone) |
| Ethernet Interface (x2) |
8-position, shielded RJ-45. Auto-sensing 10/100Base-TX with half or full duplex operation.
Model 1211E has one 10/100Base-TX port. |
| Protocol |
Transparent to high layer protocols: supports 802.1Q VLAN tagged or untagged frames.
Transparent to IP Video schemes: fully transparent to such compression schemes as MPEG-4, H.264, and MJPEG. |
| Target SNR Modes |
6 dB and 9 dB |
| Management |
8-position DIP switch |
| Monitoring |
6 LEDs display status for the following:
- Pwr (Power)
- Line
- Eth (Ethernet) 0 & Eth 1
- R (Remote)
- L (Local)
|
| Power Supply |
External AC: 100–240 VAC |
| Compliance |
FCC Part 15A, CE Mark, EMC Directive 89/336/EEC, Low-Voltage Directive 73/23/EEC |
| Environment |
|
| Dimensions |
1.18 W x 4.28 H x 3.36 D inch (30.2 W x 108.7 H x 85.3 D mm) |
| Weight |
1 lb 6 oz (623.7 g) |
| MTBF |
77,000 hours |
|
|
