The network module isolator 10/100/1000 MBit/s for the installation in
network outlets with RJ45 FM global outlet 2x1 port. The cable whip exits from
the isolator back through openings of the cup into the cable channel and
connects there with the field jack mounted on the installed network cable. This
connection outside of the outlet cup offers the advantage of a simple assembly
and while opened the trunk it allows measuring the build-in installation cable
with standard This is necessary, since the galvanic separator of the network
insulator prevents measuring the whole link from the outlets side. If screened
cables are used, the screen can be put to the field-mountable RJ45-socket on the
shielding. Field configurable RJ45-jacks exhibits hereunto a the connection with
a lug. The network isolation module not continue the screen, since thereby the
isolation effect would be waived. module isolator 10/100/1000 MBit/s is
conceived on in network outlets with RJ45 modules, e.g. . The cable whip exits
from the openings of the cup into the cable channel and connects there with the
field-configurable RJ45- on the installed network cable. This connection outside
of the outlet cup offers the advantage of a simple assembly and while opened the
trunk it allows measuring the in installation cable with standard measuring
instruments. ry, since the galvanic separator of the network measuring the whole
link from the outlets side. If screened cables are used, the screen can be put
to the socket on the shielding. Field- s hereunto a grounding latch for the
connection with a lug. The network isolation module does the screen, since
thereby the isolation effect.
Norms / Standards
|
|
IEC 60601-1 resp. EN60601-1:X2006
|
Electrical strengh between the
network connections |
|
4KV |
connections |
|
1x jack RJ45, 8-pole and 1x plug
RJ45, 8-pole |
Attenuation
|
10Mbit/s (0-30MHz) |
-0,8db |
|
100Mbit/s (0-31,25MHz)
|
-0,8db
|
|
1000Mbit/s (0-62,5MHz) |
-2db |
1 Network specification
|
|
IEEE 803.2 10/100Base-T IEEE
802.3ab 1000Base-T Twisted Pair, auto-conf
|
1If the link length is > 80m, the
transmission power for 1Gbit/s cannot be guaranteed
in general. Please check installation first.
|
|
|
Mode of operation
|
|
Permanent operation
|
Site conditions
during operation |
Air pressure
|
860hPa to 1060HPa
|
|
Temperature |
-25°C to 85°C |
|
Relative humidity
|
10% bis 90% (not condensing) |
Dimensions without
cable |
|
(52x23x17)mm³
|
Cable length
|
|
(Standard) 120mm
|
|