The INJ-102GT++ PoE Injector series is not only an IEEE802.3at compliant
device but also an advanced high power PoE injector. It is intelligent detection
that provided 2-ports 10/100/1000Base-T (X) PoE outputs. The device does not
turn on power until it detects a valid PoE signature from the PoE devices
attached downstream on the Ethernet cable. This protection against damage to
non-PoE compliant equipment which may be connected to the Ethernet cable.
Therefore, only an IEEE 802.3at/802.3af compliant device can be powered with the
INJ-102GT++ PoE Injector. Typically in Gigabit networks the maximum allowable
CAT5 cable length is about 100 meters, due to the limitation of the Ethernet
standards. Because of its 24~57VDC power input with boosting circuit, the total
output power can be up to 180Watts[Note2] for all ports usage. The installer
doesn’t need to worry about voltage drops caused by cable length. The
INJ-102GT++ PoE Injector can function with any PoE P.D. equipment which is fully
compliant with the IEEE 802.3at/802.3af PoE standards.
Note1: The equipment being powered must be fully IEEE 802.3at/802.3af
compliant in order for the power supply to be able to sense the PoE devices
signature and apply power. Power is supplied on Ethernet pins 1/2 (V+) and 3/6
(V-).
Note 2: LTPoE++TM PSE technology is applied on this product. Only when an
LTPoE++ TM Powered Device (PD) is attached can the PSE port deliver up to 180W
of output power.