Moxa CP-602E-I w/o Cable - 2 Port CANbus PCI Express Board, w/Isolation, 0 to 55 Degree C Temperature
by MOXA

Moxa’s new CP-602E-I CAN (Controller Area Network) interface board supports the PCI Express interface. As a stand-alone CAN controller, the CP-602E-I is a cost-effective solution that provides two active CAN controllers with a DB9 connector on the same board. The CP-602E-I CAN interface board uses the NXP SJA1000 and transceiver PCA82C251, which provide the bus arbitration and error detection. The -40 to 85°C wide operating temperature (CP-602E-I-T only) and 2 kV isolation make the boards suitable for use in harsh industrial environments.

• Hardware
Connectors	DB9 male x 2
CAN Controller	NXP SJA1000
CAN Transceiver	PCA82C251
CAN Specification	CAN 2.0 A/B
Signal Support	CAN_H, CAN_L, GND
Transfer Rate	1 Mbps
Max. Number of Boards per PC	4
Electrical Isolation	2 kV
Termination Resistor	120 ohm (selected by jumper)
• Driver Support
Operating Systems	Windows 2000, Windows XP/2003/Vista/2008 (x86/x64)
Linux Real TTY Drivers	Linux 2.6.x, 3.x
Note	Please refer to Moxa’s website for the latest driver support information.
• Software
Libraries	Visual C/C++, Borland C/C++
• Environmental Limits
Operating Temperature	Standard Models: 0 to 55°C (32 to 131°F) Wide Temp. Models: -40 to 85°C (-40 to 185°F)
Storage Temperature	-40 to 85°C (-40 to 185°F)
Ambient Relative Humidity	5 to 95% (non-condensing)
Altitude	Up to 2000 m
Note	Please contact Moxa if you require products guaranteed to function properly at higher altitudes.
• Standards and Certifications
EMC	CE, FCC
EMI	EN 61000-3-2, EN 61000-3-3, FCC Part 15 Subpart B Class B
EMS	IEC 61000-4-2, IEC 61000-4-3, IEC 61000-4-4, IEC 61000-4-5, IEC 61000-4-6, IEC 61000-4-8, IEC 61000-4-11 (DIPS)
Green Product	RoHS, CRoHS, WEEE
• MTBF (mean time between failures)
Time	248,563 hrs
Database	Telcordia (Bellcore), GB
• Power Requirements
Power Consumption	780 mA @ 5 VDC

CP-602E-I w-o Cable.pdf

479 K