The TP-SSW5-NC Power Over Ethernet (POE) 10/100Mb switch offered by Tycon Power Systems is a fully automatic high speed 5 port Ethernet switch with up to 2A of POE power per port. It uses passive POE
The unit supplies passive PoE power to the remote device on the unused Ethernet pins 4,5(V+) and 7,8(V-). The Ethernet spec supports distances up to 100m (328 feet) between the PoE switch and the remote device.
The switch accepts DC power from any power supply. The PoE output voltage equals the DC voltage of the power supply used from 12V to 57VDC. There are 2 power inputs for attachment of primary and secondary power sources
Ethernet Standard |
IEEE802.3/IEEE802.3u |
Ports |
1 data /P o E input and 4 data/P o E, automatic crossover and polarity |
Transmission Speed |
100 Mbps /10 Mbps Auto - negotiation |
Switch Technology |
Store and Forward |
Protocol |
CSMA/CD |
Flow Control |
IEEE802.3x(full - duplex), Back Pressure(half - duplex) |
Data Transmission Rate |
148800pps , 14880pps |
Address Table |
1K MAC, self - learning |
Connections |
Shielded RJ45 |
POE Output Ports |
Port 1 - 4, auto power management Pin assignment: TX(1,2), RX(3,6), V+(4,5), V - (7,8) |
Maximum POE Power |
2A per port |
POE Auto Detection |
Passive P o E |
POE Protection |
Over Temperature, Over Current, Over/Under Voltage |
Data Surge Protection |
IEC61000 - 4 - 2 (ESD) ±15kV (air), ±8kV (contact) IEC61000 - 4 - 4 (EFT) 40A (5/50ns) IEC61000 - 4 - 5 (Lightning) 20A (8/20μs) |
LED’s |
Link (Green On), Activity (Green Blinking ) P o E Detect (Yellow On), P o E Detect Error (Yellow Blinking) Power On (Green On), Power On Alarm (Red On) |
DC Power Input |
12V to 57VDC, Dual DC Inputs, Reverse Polarity Protected |
Self Consumption |
< 1 Watt |
Operating Temp |
- 40 to +85°C ( - 40 to 185°F) |
Operating Humidity (RH) |
5% - 90% (non condensing) |
Storage Temperature |
- 55 to + 8 5°C ( - 67 to + 185 °F) |
Dimensions (LxWxH) |
90 x 118 x 40mm (3.5 x 4.6 x 1.6”) |
Weight |
182g (6.7oz) |
Warranty |
2 Years |
|