Need assistance or guidance?

Contact us @: 1-800-301-9097
Login / Register Contact Us
 
F-8084 - 8 Ch, Single/Duplex, frequency 0~100KHz, Isolated, one COM for all PI by ICP DAS

F-8084 - 8 Ch, Single/Duplex, frequency 0~100KHz, Isolated, one COM for all PI
by ICP DAS

Write a review Write a review

32-bit High Speed Counter / Frequency module for use with iDCS-8000 redundancy I/O racks. Counts up to 500 KHz input signal with Accuracy of +/-0.4% FSR. When in redundant mode, if a failure occurs, the slave module takes over.

Mfg SKU # : F-8084
List Price : $1,199.00
Our Price : $1,176.00
Stock : Call for Availability
Quantity :

The F-8084 is a 32-bit high speed up-counter/frequency module. It can count up to 500 KHz input signal, and accuracy of the frequency mode is +/-0.4% FSR. The F-8084 features many diagnostic like some failures of communication, EEPROM, WDT, decoder, etc. When the modules are in the redundant mode and a failure occurs the slave module will take over as soon as possible. Moreover, the redundant switching is not only fast but also reliable for data exchanging. Thus, users can easily to use F-8084 to count.

  • 32-bit counter
  • 8 up-counter/frequency channels
  • 1 ~ 32767 us digital filter
  • Falling/Rising/Both edge trigger
  • RoHS compliance
  • 3000 VDC isolation from input to frame ground
  • 3000 VDC isolation from output to backplane
  • 3000 VDC isolation from output to frame ground
  • Redundancy
  • No error counting when redundant switching
Feature
Redundant Yes (The counting error less than 1 counter when input signal < 10 KHz)
Termination board break off detection Yes
Digital filter Yes (1~32767us)
LED indicator 1 RUN, 1 ACT, 1 DUX
Pulse Input
Number of channels 8
Type Counter/Frequency
Min. Pulse Width 2 us
Input Frequency Range 1 Hz ~ 500 KHz
Rated Voltage 30 VDC
Input voltage range, "1" 4.5 VDC~ 30 VDC
Input voltage range, "0" < 1 VDC
Detection time 2 us
Input impedance 200/500/1KΩ or none (5 KΩ)
Nominal input channel current 20mA @ 24VDC
Maximum input current 25mA @ 30VDC
Isolation 3000 VDC
Certification
EMC EN61000-6-2, EN61000-6-4, IEC/EN 61000-4-2, IEC/EN 61000-4-4
General
Termination board DN-PI-M
Maximum power consumption 1.9 W
Operating temperature -25°C ~ +75°C
Humidity 5 ~ 95 % RH, Non-condensing
Weight 300 g
Dimensions (W x L x H) 30 mm x 85 mm x 115 mm
F-8084.pdf1,913 K

Copyright © 2024 iComTech. All rights reserved. Shopping Cart Software powered by ecMidas.